diymainimage

Capped Tassels

Materials

1. Nylon thread 2. Bead cone 3. 2 inch Eye Pin 4. Glue 5. Small and large beads

Materials

Instructions

Steps
Step 1
Wrap the nylon thread about 15-20 times or more around a 7-8 inch long piece of cardboard. Carefully remove the string and tie another piece of thread tightly to the center of the wrapped string.
Steps
Step 2
Open the hook on your 2-inch eye pin with your round nose pliers. Hook it through the thread you just tied in the center of the string. Close the open hook end of the pin with pliers.
Steps
Step 3
Add a dot of glue where the hook is looped through the thread to secure the knot and hook. Add a dot of glue inside the cap/cone.
Steps
Step 4
Feed the straight end of the eye pin through the cap and pull tightly. Let it dry. Add your beads.
Steps
Step 5
You may need to trim the end of the pin if it is too long. Grab the tip end of the pin with the round nose pliers and curve it around to make a loop. Make sure the end meets the pin. Trim the ends of the tassel and that’s it! You could add these to so many things, jewelry, pillows, lamp or fan pulls, you name it!

తెలుగు లోకి
మారండి