Cut your can about an inch to an inch and a half from the top. It doesn’t need to be perfect.
Cover it with tape. If your tape is too wide, snip it at intervals and fold into the ring. Trim your dowel to size.
Punch a hole halfway into your ring. Stick your dowel in place with glue and allow it to dry!
Cut off the neck of your balloon and pull your balloon over the opening on one side of your ring. Secure it in place with a strip of pretty tape.
Poke a hole in each side using your knife. Poke a piece of ribbon and secure it with a knot on the inside and the outside. Add your bead(s,) knot them to secure, and trim. Seal the open side of your ring with another balloon, the same way you did with the first. That’s it!