Take piece of paper and fold it in half. Mark the dots as shown in the illustrator and draw, a line connecting these two dots.
Fold the top corner of the paper down along the line. Next, flip the paper over and fold the other side down to match the side you just folded.
Flip the paper back over and tape along the middle seam. Lay a skewer across the kite, as shown, and tape it in place. Flip the kite back over and straighten the "spine".
Mark a spot about a third of the way down the spine, and about half an inch from the edge. Put tape over this mark to reinforce it on both sides. Use your hole punch to make a hole in this spot.
Tie your kite string through this hole. Then tape a length of ribbon to the back of the kite, at the bottom. That’s it your kite is ready to fly!