Choose the two pom poms cut approximately 2 ft. / 60 cm. of thread and thread your needle. Push your needle through the center of one of the pom poms, leaving a long tail.
Next, thread the needle through one end of your bar connector and take the needle through the center of your pom pom. Pull on the thread so the end of the bar connector is resting up against the pom pom.
Repeat Step 2 twice, or until your pom pom feels securely attached to your bar connector. Tie the ends of your thread using a double knot. Trim excess thread.
Use both pairs of your pliers to open a jump ring. Next, slide the jump ring through the top hole of the bar connector. Add the ball earring post. Close the jump ring.
Repeat steps 1-6 to make your second earring. All done!