diymainimage

String Bracelet

Materials

1. Golden Spacer Bead 2. Crimp Bead 3. Lobster Claw Clasp 4. 0.5mm Tiger Tail Wire 5. 1mm Nylon Thread 6. Flat Nose Plier 7. Scissors

Materials

Instructions

Steps
Step 1
First, cut a 50cm long wire and attach a crimp bead at 5cm from the end; slide the spacer bead one after one twice the length of your wrist and attach another crimp bead at end to stop falling.
Steps
Step 2
Now, fold it in half then, fold beaded strand and loop the thread around the area between first two beads. Bring one end going over the beaded strand and the other one going under.
Steps
Step 3
Now twist two ends together to turn the cord in opposite direction. Angling down to the next gap and repeat the process above. Continue crossing over and filling in the gaps.
Steps
Step 4
Remove the two crimp beads at ends and tie the two ends of tiger tail wire; secure two thread ends with a tight knot. Make sure and then trim off any excess thread.
Steps
Step 5
Open the jumprings and attach the clasp at end. So, there you’ve your new string bracelet!

తెలుగు లోకి
మారండి